To avoid this safety-trigger to be activated, the battery pack should be charged at least once every few months. The contents of Lithium-Ion batteries is under pressure and the packs can explode if exposed to extreme heat. Lithium-Ion battery units should therefore never be incinerated and should not be thrown into the household trash, but put into the recycling stream. Most places that sell camera batteries will also accept them back for recycling. A potelyt. PW , 1-Aug Is there a car charger available for the EN-EL9a?
Is the EN-EL9a available in colors other than grey? How should the EN-EL9a be stored? How should I discard my old battery pack? X Thanks for your vote! You rated this page 4 out of 5. Any additional comment or suggestion for improvement would be welcome. Yet, it works sometimes. Remove the battery then rub it on your hand for a good amount of time. It may recharge the battery enough to turn the camera on. Search per battery for the plus and lower connectors.
Fit the charging battery voltage and other batteries such as AA, AAA, or other battery that are efficient enough to supply. Get a double metal cable section. Type the wires into a charging battery and the battery requires charging. The battery needs to be charged for a while. To get a half amp to switch into the camera battery, use 3 Christmas lightbulbs at one time as a present regulator. As there are about 13 volts of battery for a vehicle, and about 7 volts of battery for your camera, the bulb would have 6 volts.
Three bulbs must be mounted in parallel to flow through the battery around 0. Less than 0. You will make calls on your mobile or something before your battery is full enough to take pictures again. Do not leave it unattended or continue to charge the battery entirely. Poor stuff could happen when you charge too long, and your camera battery reaches 8 volts.
You can also catch fire. It is possible. Find a DC power source. The likely reason is a USB output is 5V and the DSLR battery is 7V, which means it would require an internal voltage converter that would add size and weight to the camera body.
Insert the battery and plug the charger in depending on the country or region, the charger comes with either an AC wall adapter or a power cable. An exhausted battery will fully charge in about two hours and 35 minutes. You can plug it into a USB car charger. And you can plug it into mobile USB powerbank for true on-the-go charging. Insert the battery as shown in the illustration on the charger. Remove the battery when charging is complete.
Remove the battery and unplug the charger. Terminal cover.
0コメント